0086-571-88220971 [imèl pwoteje]
0 atik

SMR bwat mete kanpe
Satisfactory effectiveness is dependent upon proper installation. lubrication and servicing. for that reason it is crucial the directions during the installation and servicing leaflet. provided with each and every gearbox. are followed very carefully. several of the important elements of belt and torque-arm set up are listed below.
one. Install pulley on gearbox input shaft as near on the reducer probable, and mount reducer on driven shaft as shut to bearing as sensible. failure to perform this will likely induce excess loads during the input shaft bearings and output bearings and could trigger their premature failure.
2. Install motor and wedge belt drive with the belt pull at around 90° on the center line involving driven and input shafts. this will permit tensioning in the wedge belt drive together with the torque arm which must preferably be in tension. if output hub runs anti-clockwise. torque arm need to be positioned the right.
3. lnstall torque-arm fulcrum on the rigid assistance so that the torque-arm are going to be at somewhere around ideal angles to the center line with the driven shaft along with the torque arm situation bolt. make certain there may be enough get up during the turnbuckle for belt stress adjustment.
Kontinye kenbe fèmen.
Bell drive may very well be situated in any convenient postion. if the torque arm should be to be utilized to tighten the belts, the drive should be at about tight angle to your line between the input and output shafts.
Bell drive could be located to the suitable if wanted.
If output hub rotates clock-wise. position belt drive and torque arm in opposite path to that proven during the illustration.
Koupl bra ak senti konsidere.
Torque arm may very well be mounted on the suitable if preferred.