0086-571-88220971 [imèl pwoteje]
0 atik

The next information and facts is necessary when making a Grid coupling choice:
Description of motor or engine, the horse electrical power (or KW), and RPM at slowest coupling pace whilst under load
Description of your driven equipment
Shaft and keyway sizes and also the sort of fit for driver and driven products (clearance or interference)**
Separasyon aks (BSE)
Physical space limitations (see Application Worksheet)
Determine what the environmental conditions is going to be, this kind of as temperature, corrosive disorders, interference from surrounding structures, and so on.
By default, sizes 1020 – 1090 might be clearance match, sizes 1100 – 1200 are going to be interference fit.
** Pou machin avanse tout raz ak keyways pou rankontre dimansyon ak tolerans spécifications pa ANSI / AGMA 9002-B04 pou pous raz, oubyen ISO 286-2 pou metrik.
Normal grid couplings consist of two grid hubs, a grid spring, and also a cover assembly. Once the shaft separation demands a spacer type coupling, the coupling will include two shaft hubs, two spacer hubs, a grid spring, as well as a horizontal cover assembly.
Formulas Made use of To Determine Torque:
Application Torque (in-lbs) = ( horse power x 63025 ) /RPM
Aplikasyon koupl (Nm) = (pouvwa chwal x 9550) / RPM
Assortment Torque = Application Torque x Service Issue
Gwo charj pik ak aplikasyon pou fren
For applications where higher peak loads or large braking torques might be current, the following added information and facts will likely be vital:
System peak torque and frequency
Devwa sik
Fren koupl Rating
The assortment torque formula is similar to the formula shown above except that the application torque needs to be doubled before applying the services issue.
Aplikasyon koupl (nan-lbs) = (chwal elektrik pouvwa x 63025) / RPM
Aplikasyon koupl (Nm) = (pouvwa chwal x 9550) / RPM
Choice Torque = 2 x Application Torque x Services Factor
Ways In Picking A Grid Coupling
Stage 1: Figure out the application torque employing the formula proven over.
Step 2: Select the Service Factor through the charts .
For applications not displayed use the chart shown for the right. Identify the Choice Torque using the formula shown over.
Stage 3: Employing the variety torque as calculated, refer towards the Performance Chart
Stage 4: Compare the maximum bore to the size selected and be certain the demanded bore sizes usually do not exceed the utmost allowable. Should the necessary bore dimension is bigger, phase up to the following size coupling and check to see in the event the bore sizes will fit.
Phase 5: Employing the picked coupling dimension, review the bore and keyway sizes
Step 6: Speak to your community industrial supplier together with the component numbers to area sizes with all the charts for UPC aspect numbers.